Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 61 (kliknij aby zobaczyć)
Timer Recording
6 After making the settings, press ENTER.
The program details are shown at the bottom of the screen for a few seconds then the screen is automatically exited.
6
G-Code programming with the power off
You can enter a G-Code programming number when the recorder is in standby.
If you haven�t set up the guide channels (or at least the guide channel for the G-Code programming number that you entered), the recorder will prompt you to enter the channel number that the TV program is showing on.
� You can�t use this feature until you have set up the guide channels. See page 28. � You can�t change the recording mode. � You can�t program daily or weekly timer recordings.
1
Press the G-CODE button.
The front panel display shows the current recording mode and prompts you to enter the G-Code programming number.
2 7 Make sure that you switch the recorder into standby before the timer recording is due to start.
Timer recording will not work if the recorder is left on! � The recorder will automatically switch on two minutes before the timer recording is due to start.
Use the number buttons to enter the G-Code programming number.
� To clear the last digit entered, press CLEAR.
3
Press ENTER.
The display shows the timer settings: Date = Start time = Stop time = Recording mode/channel. � If CODE ERROR appears in the display, check the G-Code number and start again from step 1. � If CANNOT RECORD appears in the display, it means that although you entered a valid G-Code number, the program cannot be recorded for some other reason (if there is a timer recording already set for that time, for example).
� If you need to check or change anything in the program, press SETUP, then ENTER to display the timer recording program screen. From here you can check, change or clear any settings you want.
