ONKYO DVSP501
Instrukcja Obsługi

Connecting the Power/Turning on the DV-SP501
Before connecting � The DV-SP501 is shipped with the POWER switch in the on position ( ON). When the power cord is plugged in for the �rst time, the DV-SP501 will automatically enter the standby state and the STANDBY indicator will light (same condition after step 2 below). � Make sure that all the connections on pages 18 � 22 are complete (the connection to a TV is required).

3
STANDBY/ON

STANDBY

STANDBY/ON

STANDBY/ON

PAUSE

STOP

PLAY

DISPLAY STANDBY

PLAY MODE

TOP MENU

CU

RSOR

MENU

POWER

DIMMER

CLEAR

RETURN
PU

SETUP

SH TO ENTER

ON

OFF

Press STANDBY/ON on the DVD Player or ON on the remote controller. The DVD Player turns on and the STANDBY indicator turns off. � To put the DVD Player in the standby mode, press STANDBY/ON on the DVD Player, or STANDBY on the remote controller. Be sure to set the volume to minimum before putting the DVD Player in the standby mode for the next use to avoid sudden loud sound reproduction. � While the STANDBY indicator lights up, the DVD Player can receive signals from the remote controller. However, if you press POWER on the DVD Player to switch off the main power, the remote controller cannot be used to turn on the DVD Player. � Setting the STANDBY button to standby does not shut off the power completely.

POWER

1

Plug the supplied power cord into the AC INLET and then into the power outlet on the wall. � Do not use a power cord other than the one supplied with the DV-SP501. The power cord supplied is designed for use with the DV-SP501 and should not be used with any other device. � Never have the power cord disconnected from the DV-SP501 while the other end is plugged into the wall outlet. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and disconnect by unplugging from the wall outlet �rst.
AC INLET

Note: � This player features a screen saver and an auto power off function. If the player is stopped and no button is pressed for �ve minutes, the screen saver starts. If the disc tray is closed but no disc is playing and no control is pressed for 30 minutes, the player automatically goes into standby.

To a wall outlet

2
POWER
ON OFF

Press POWER to switch on the main power. The DVD Player enters standby mode. The STANDBY indicator lights up. � The buttons on the remote controller do not operate if the POWER switch is set to OFF. � To switch off the main power, press POWER again.

23