Options
Temp Boost Sensor If for any reason the incoming water temperature is below 120°F, press the On button to assure the water is heated to proper temperature for best cleaning and drying results. The dial will pause at the a/_ to extend the main wash and the Heating Delay light will turn on. Press the Offbutton to cancel the Temp Boost Sensor. Heated Rinse RINSE TEMP and Dry Options
To Start
Dishwasher
After loading set tbe dial to the desired cycle. Press button for desired options. NOTE: Run the water from the hot water tap to clear the line of cold water before starting. Press the door until it latches. Tile cyele will begin with a drain prior to fill. Indicator Lights
The Heating Delay light indicates that the main wash is being extended to heat the water to proper temperature. At the end of the dry phase clean will remain lit until the dial has been advanced to the _.
Press the Sani button to turn the heating element on during J1 rinses. The Sani option helps maintain water temperature and improve drying results. Press the Norm'a] button if Sani is not desired. The heating element will be turned offfor all rinses. FAN DRY Press the Heat button to turn the heating element on during the fan dry period. This option improves drying results, Press the Mr button to turn the heating element off during the }:andry period. Towel drying may be necessary, NOTE: Temp Boost Sensor, Rinse Temp and Fan Dry options can be used separately or together.
Adding
a Forgotten
Item
For best cleaning, the forgotten item should be added early in the cycle. 1. Unlatch the door and wait until the sound of circulating water stops. 2. Open the door and add the item. 3. Pause before latching the door. The cycle will continue at the point it was interrupted.
