WHIRLPOOL ED19VKXRWR0
Instrukcja Obsługi

Changing the light bulbs.. .
WARNING: Before removlng a light rhleld for cleaning or for replaclng the bulb, either unplug retrlgemtor or dlsconnect electrlclty leadlng to refrlgerator at the maln power supply. Shock and Injury can occur If electrlclty remains connected.

Pull Off the Dial; Pull Out at the Bottom

light bulbs behind refrigerator trol consoles:

and freezer con-

1. Pull control knob straight off. 2. Pull bottom of control panel straight out. 3. Lift top of panel off supports. 4. Replace with a 40-watt appliance bulb. 5. Replace panel in reverse order.

Removing the base grille...
1. Open the doors. I II

support

Tabs

To replace:
2. Pull grille outwards as shown. 3. Do not remove Tech sheet fastened behind grille. 1. Line up grille support tabs with metal clips. 2. Push firmly to snap into place. 3. Close the doors.

Ice cube trays.. .
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

To remove ice:
1. Hold tray at both ends. 2. Slightly twist.
l l

Optional automatic ice maker.. .
If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-61). there are a few things you will want to know: The ON/OFF lever is a wire signal arm. l Down...for making ice automatically; Up...toshut off the ice maker. Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. On -..

l

l

l

l

l

Lower Arm to Shrt It.
l

Arm to Stop Ice Maker.

l

It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you.

The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored OToff-flavored. Discard the first few batches of ice. Your ice maker will work faster when the freezer is colder. If you want rnme ice, turn the Temperature Control to a higher number, or turn the Air Control to a higher number. If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation. Good water quality is important for good ice quality It is not recommended that the ice maker be connected to a softened water supply Water softener chemicals such as salt from a malfunctioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water softener be well maintained and operating properly 7