Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
Plan to remove and empty the storage bin:
l
l
l
If the Ice dispenser has not, or will not be used for a week or more, If a power failure causes Ice In the bin to melt and freeze together, If the ice dispenser IS not used regularly.
1. Pull the coverrng slrde it to the rear.
panel
out from the bottom
and
2. Lift the signal arm so it clicks into the OFF position. Ice con still be dispensed, but no more will be made.
Night
Light Switch
3 Lift the front of the storage
brn Pull it out IO-watt bulb. It should last about 10,000 hours. When it burns out, purchase another from your dealer.
4 Empty the bin Use hot or worm water to melt the ice If necessary Never use anythlng sharp to break up Ice in the bin This con damage the bin and dispenser mechanrsm. 5 Wash with mild detergent. Rinse well.Do not use harsh or abrasive cleansers or solvents. 6 When replacing the bin, make sure it is pushed in all the way Push the signal arm down to the ON position to restart ice production
the night light uses a heavy-duty
Removing
the freezer basket.. .
For proper air movement, keep the freezer basket In place when the refrigerator is operating.
To remove the basket:
l l l
Slrde out to the stop. Lrft the front to clear the stop. Slide out the rest of the way.
To replace
l l
the basket:
Jl-
l
Place basket on the slides. Make sure the wire stops clear the front of theslides Slide basket in
