Operating sequence
Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 20 minutes. There may be dust inside a brand new tumble dryer.
After each use
� Switch the appliance off by turning the programme selector dial to �0�. The mains-ON light goes out. � Clean the filter and empty the water reservoir (see page 13). Important! If the drying programme has to be stopped before it reaches the end, we recommend that you turn the programme selector dial to position (cooling) and wait until the end of this phase before removing the laundry. This will avoid a build-up of heat inside the appliance. Modifying the programme To change a programme which is running, first cancel it by turning the programme selector dial to �0�. Select the new programme and press the Start button .
Drying
1. Connect the appliance. 2. Open the door by pressing the relevant button. 3. Load the items one at a time, shaking them out loosely. 4. Close the door. Please check the laundry does not get caught between the door and filter. 5. Select the drying programme or time: the mainsON light comes on. 6. If required, press the low temperature button and/or the buzzer OFF button . 7. Press the Start button : light comes on and drying starts. The drum turns alternately in both directions during drying. All drying programmes end with a 9 minute cooling phase (the light is on and the buzzer sounds). You may remove the laundry after this phase. 8. If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasing phase (duration: 30 minutes maximum). The buzzer sounds every 10 seconds (if the button has not been pressed). Lights and flash alternately. If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. Lights and flash alternately and the mainsON light stays on. Turn the programme selector dial to �0�, all the lights go out. 9. Remove the laundry.
