Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
4. Place pans of hot water inside freezer to hasten melting of frost. Leave door open. As ice softens and melts, it con be removed In large pieces. Direct air from on electric fan into the freezer to speed defrosting.
9. Plug cord into wall outlet and return cold control to original setting. Check to see that the signal light glows. Return food to the freezer. NOTE: Cleaning waxes, concentrated detergents, bleaches and cleansers containing petroleum products should not be used to clean door gasket or plastic parts of the freezer.
6 Wash inside of freezer with a solution of 2 tablespoons of baking soda to one quart of warm water. Rinse and dry. Wash the gasket strip around the door with worm, soapy water. Rinse and dry.
Replacing interior light
5 Remove drain cop from inside bottom of freezer. Remove the base grille by opening the freezer door and lifting up ontwo tabs that extend through the grille at either end. Pull grille forward and lift off bottom supports.
Disconnect electric cord from outlet. Remove light shield by pulling away from the side wall. To replace, insert tabs into opening in freezer side wall and press. Replace bulb with no larger than a 40.watt appliance bulb. Reconnect freezer.
Unclip hose and allow defrost waterto drain through the hose into a flat pan. After defrosting and cleaning, hook drain hose in place and replace the base grille and drain cap.
7. Wash outside of freezer with worm water, using a mild soap or mild detergent. Rinse and dry. Do not use an abrasive or harsh cleanser. Waxing is not recommended 8. Clean condenser located behind the base grille with a stiff brush or with the dusting attachment from your vacuum cleaner.
