Do not connect the power plug to a power outlet until all preparations have been completed.
1 Extend the two legs of the DLA-G10U/E by rotating.
Rotate until rotation becomes stiff and then stop to prevent damage. The other legs of the projector do not rotate. Peel off the rubber pad adhered to one of the legs so the embedded nut is visible. Rubber pad Prepare the following tool Screwdriver
Leg
2 Remove the 4 adjustment screws and remove the ceiling mount. Remove the 2
screws from the ceiling mount and open the mount 90 degrees. Remove 2 screws and then detach the stopper from the front of the mount. Ceiling mount Top fitting
Stopper
Vertical adjustment screw
Hinge
CAUTION
8
Use care to prevent the top fitting from dropping during the installation work since this could result in injury or damage.
