Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 29 (kliknij aby zobaczyć)
CLEANING THE SHELVES, WIREWORK RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle, can be washed in the dishwasher. The grill pan, grill pan grid, oven shelves and wirework runners may be cleaned using a soap impregnated steel wool pad. Soaking first in hot soapy water will make cleaning easier.
Fit the new bulb by turning in a clockwise direction until it is secure. Ensuring the indent to the flange is pointing to the rear of the oven, replace the glass by pushing it firmly into the hole to cover the bulb assembly. Replace the shelves and wirework runners. Restore the electricity supply and adjust the time of day and clock as necessary.
TO REMOVE THE WIREWORK RUNNERS
The wirework runners in the grill and oven cavities can be removed for cleaning. 1. Remove all shelves and furniture from the grill and oven compartments. 2. Hold the wirework at the bottom, unclip from the cavity side and gently pull towards the centre of the grill or oven compartment. 3. Unhook the runner at the top and remove from the cavity.
SIDE PANEL CAVITY CENTRE
CLEANING THE DOOR GLASS
To prevent damaging or weakening the door glass panels avoid the use of the following: · Household detergents and bleaches Impregnated pads unsuitable for nonstick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers · ·
4. To replace, hook the wirework runner back into the grill/oven sides. Ensure that the wirework runners are firmly in place before refitting the oven shelves.
· · ·
REPLACING THE OVEN LIGHT BULB
The type of bulb required is a 300°C 25 watt small Edison Screw. Part number 572 491 5431-00/1 (Available through your local Service Force Centres). The main oven and second oven inner door glass panels are removable for cleaning. Under no circumstances should the door assembly be detached from the product for cleaning. Please refer to the cleaning instructions.
CAUTION:
DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE BULB. Open the door and remove the shelves and wirework runners to enable easy access to the oven light assembly. Insert a flat blade screwdriver between the oven side and glass which covers the bulb. Support the glass with your hand and prise out sufficiently to release the glass cover. Unscrew the bulb in an anticlockwise direction until it is possible to remove the bulb with ease.
