Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 14 (kliknij aby zobaczyć)
When removing the control panel stand cover
1. Insert the head of a flat-tip screwdriver in the gap under the mark (O). 2. Push the bottom tab of the cover up to lift the cover. 3. Perform the same procedures as 1 and 2 above for the other gap. 4. Pull the cover up diagonally. � Performing this procedure with the allen key or a Phillips screwdriver could damage the unit. 1 2 Flat-tip screwdriver (Not included in the standard configuration) Gap
2
4 Raising the backrest to the
upright position
1. Insert the power plug into the power outlet. 2. Confirm the key lock is set to the �open� position. 3. Confirm the power switch is set to the �on� position. 4. Press the button on the control panel twice. The backrest will rise to the upright position automatically.
