Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 16 (kliknij aby zobaczyć)
Shelf holders
Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers.
A
B
Door reversal directions
1. Disconnect from the electricity supply. 2. Remove all loose items, including food, store food in a cool place. 3. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing. 4. Remove the feet (B). 5. Remove bottom hinge (A). 6. Remove the freezer door by releasing it from the middle hinge (H). 7. Unscrew the middle hinge. 8. Slide out the fridge door from pin (G), unscrew pin (G) and then screw it down into the hinge hole provided on the opposite side, after having removed the small plugs which should then be fitted on the opposite side. 9. Remove the plastic blanking screws from the left hand hinge position, refit to the right hand hinge position. 10 Refit the fridge door and replace the middle hinge to the left hand side. 11.Replace the door and bottom hinge (A) on the opposite side. 12.Refit the feet (B).
G
H
D715 PIED/M
B
A B
Attention
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
