|
|
|
Kto jest w sklepie?
Sklep przegląda 5988 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Ice compartment door...
Pull the ice compartment door panel bottom and slide it to the rear.
out from the
Ice cube trays...
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
To remove Ice: 1. Hold tray at both ends.
2. Slightly twist.
Automatic ice malcet..
If you have Model ET20DM and have the automatic ice maker accessory, or if you have Model ET20DK and plan to add one later (Part No. ECKMF-831, there are a few things you will want to know: The ON/OFF lever is a wire signal arm. l Downfor making ice automatically. Up...to shut off the ice maker.
l l
l
DO NOT TURN ICE MAKER ON UNTIL IT IS CONNECTED TO THE WATER SUPPLY.
The dial changes or lever on the side of the ice maker the size of the cubes.
l
l
l
l
Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity It is normal for ice crescents to be attached by a corner. They will break apart easily.
l
You will hear water running when Ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the flrst few batches of ice. If Ice is not being made fast enough and more ice Is needed, turn the Refrigerator Control toward a higher number. Walt a day and, If necessary, turn the Freezer Control toward A. If you remove the ice bin, raise the signal arm to shut off the Ice maker. When you return the btn, push it all the way In and lower the arm to the ON position. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation. Good water quality is important for good Ice quality It is not recommended that the ice maker be connected to a softened water supply. Water softener chemicals such as salt from a malfunctioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water softener be well maintained and operating properly.
l
LOWER SIGNAL ARM TO START IT
RAISE SIGNAL ARM TO STOP ICE
l
-
8
|
|
|
> |
|
