WHIRLPOOL ET20NKXSW20
Instrukcja Obsługi

Changing the light bulbs...

1. Reach behind
2. Remove 3. Replace

the control

console

to find bulbs. bulb.

bulb. with a 40.watt

appliance

Removing the base grille...
To remove the grille:

METAL CLIPS

r

7

1. Open the door 2. Pull grille outwards as shown. 3. Do not remove Tech Sheet fastened grille.

To replace the grille: 1. Line up grille support
behinc!

tabs with metal clips. 2. Push firmly to snap into place. 3. Close the door.

Ice cube trays...
It cubes are not used.they may shrink The mov1�19 cold air starts a slow evaporation. The longer c.Abes are stored, the smaller they get.

To remove ice: 1. Hold tray at both ends.
2. Slightly twist.

Optional

automatic ice maker...

It you have the automatic ice maker accessory, GI If you plan to add one luter (Part No ECKMF-83) there are a few things you will want to know * The ON/OFF lever is a wire signal arm Down...for making Ice automatically lip...to shut off the Ice maker.

DO NOT TURN ICE MAKER ON UNTIL IT IS CONNECTED TO THE WATER SUPPLY.
* !ne dial or lever on the side of the Ice maker changes the size ot the cubes. * Shakethe bin occasionally to keep cubes separ.lted,and toobtain Increased storage capacity l It IS normal for Ice crescents to be attached by a ~rner They will break apart easily 6 p-c-, Off

LOWER SIGNAL ARM TO START IT

RAISE SIGNAL ARM TO STOP ICE L

di

I

- vOCr will hear water running when Ice maker IS tiorking s(-,J7(-4:I *,heo: .P�_ fall lntn the b,r- Don�t ie! You �.�.;e -+c. Ice

The Ice maker WIII not operate until the freezer 1s cold enough to make ice. This can take overnight. * Because of new plumbing connections, the first Ice may be discolored or off-flavored. Discard the first few batches of ice. l If ice is not being made fast enough and more (ce IS needed, turn the Refrigerator Control totiard a higher number. Wait a day and, if necessary, turn the Freezer Control toward A If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON posltion. If cubes are stored too long, they may develop an off-flavor ..like stale water. Throw them away. They will be replaced. Cubes in the ice bin can nls~ become smaller by evaporation Good water quality is important for good ice quality It IS not recommended that the ice maker be connected to a softened water supply. Water boftener chemicals such as salt from a malfunc+loning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is impor-ail+ that the water operr!ting softener be well maintained properI\

l

7