D. This section backs on to Section A; it is 1 mm wider, to allow for fold
Color profile: _DEFAULT.CCM - Generic Profile Composite Default screen
page 2
page 3
page 4
Eurotel 1500
Finding the best position for the base unit
To use your handset and base unit together, you must be able to establish a radio link between them. Be aware that:
Fit the belt clip onto the handset (this step is optional)
Click the belt clip into position, making sure it is securely fitted
The base unit must never be installed near a bath or shower, or anywhere else where it might get wet.
Siting the base unit as high as possible will give better results. In a two-storey house, the best position for your base unit may be on the first-floor landing. Any large metal object (e.g. a refrigerator, mirror or filing
Align the ridge on the inside of the belt clip with the groove on the side of the handset, and fit the belt clip to one side of the handset
cabinet) may block the radio signal.
Other solid structures, like walls, may reduce the signal strength.
Insert the telephone line plug into the socket The CHARGE light comes on. When the handset�s batteries are fully charged (after about 7 hours), the light flashes.
240 V AC, 50 Hz
Plug in the mains adapter, with the switch on the mains socket set to OFF Then switch on mains power at the socket
Make sure mains power is switched on if you want to use the phone � it will not work without it
E:...\QUICKREF\E1500qr2.cdr 08 September 1998 14:40:34
FOLD
�
Remove the cover from the back of the base unit Plug in the telephone line cord and the mains power lead Replace the cover
FOLD
Place the handset on the base unit
BEEP
For details of other symbols and messages which might appear on the display, refer to page 2 of the User Guide
�Out of range� warning
If you are moving around while using your handset, and you hear a warning tone, this means you are going out of range of the base unit. Move closer to the base unit, until the tone stops If you do not move, your call may be cut off, and you may have to wait up to 30 seconds before you can use your handset again.
The Eurotel 1500 must be used with mains adapter, part no. XX002094D, supplied with the unit. Using any other adapter will result in non-compliance with EN41003, and will invalidate any approval given to this apparatus.
�
Other electrical equipment operating near your Eurotel 1500 may cause interference � keep both the base unit and the handset away from other telephones, fridges, washing machines, microwave ovens, televisions, fluorescent lights, etc.
�
�
Installation
After about 7 hours, when the batteries are fully charged, lift the handset
n n n n n
Stay near to the base unit Press the button
Hold it down for about 2 seconds, until the display goes blank Release the button then briefly press it again
For a few moments, the display flashes �
The flashing symbols mean that your handset is searching for a base unit
� � �
The display then shows
