|
Kto jest w sklepie?
Sklep przegląda 5902 gości
|
Kategorie
|
Informacje
|
Polecamy
|
|
|
|
|
Dla tego produktu nie napisano jeszcze recenzji!
Install
properly...
Remove sales labels...
Remove the Consumer Buy Guide label and any
lnslde labels before using the freezer To remove any remalnlng glue:
1. Rub briskly remove with thumb to make a ball, then
OR
2. Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water] before removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, carbon tetrachloride, etc. These can damage the material. NOTE: DO NOT REMOVE the Tech Sheet fastened under the freezer at the front.
Clean it ...
I, Check weight the strength of the floor. It should hold the of a fully loaded freezer Clean your freezer befor using it. See cleaning tnstructions on page 6.
2. Pick a safe place, indoors, away flammables such as gasoline.
from in-
3 Allow 3 inches (7 5 cm] arr space on top of freezer for proper ventrlation. 4. Allow at least an inch (2.5 cm) between the freezer condenser, on the back of the unit, and the wall 5 Allow % inch (1 25 cm) on each srde of the freezer for ease of installation. 6. If the freezer is to be against a wall, you mrght want to leave extra space on the hinge side so the door can be opened wider.
Plug it in...
j-prong grounding type wall receptacle Retaining Clip
Level freezer...
so the door will stay open at any position.
Raise
lower
Freezer 1 Power Plug Recommended
I grounding-plug Grounding Method
Start ad)ustment
with the door hinge side.
I, Slide the freezer into place. 2. Adjust front legs to level the freezer. -To raise front, turn legs clockwise. -To lower front, turn legs counterclockwise. 3. Check with level. 4. After freezer is fully loaded, recheck with level
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull chain. Do not use an extenslon cord.
Attach retaining literature package clip over power cord plug from inside the freezer.
|
|
|
> |
|