WHIRLPOOL EV190NXSW00
Instrukcja Obsługi

Changing the light bulb...
1 ,,.i., Elect;~Shock Ha,.,, Before removing a light bulb, either unplug the freezer or disconnect the electricity leadmg to the freezer at the maln power supply. Shock and injury can occur if electricity (

1. Disconnect freezer from power supply. 2. Remove the light shield from the side of the control panel. Depress the back of the shield to release the tabs, then pull away. 3. Replace the bulb with a 40-watt appliance bulb. 4. Replace the light shield. Insert the shield tabs in the slots, then press the shield to snap into place. 5. Reconnect power supply.

Removing the freezer basket.. .
For proper air movement, keep the freezer basket in place when the freezer is operating.

To remove the basket:
l l l

Slide out to the stop. Lift the front to clear the stop. Slide out the rest of the way.

To replace
l l

the basket:

l

Place basket on the slides. Make sure the wire stops clear the front of theslides. Slide basket in.

The key eject lock...
can help entrapment. reduce the hazard of child To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock. If the key is lost, contact your WHIRLPOOL dealer for a replacement. Always give the complete model and serial number of your freezer when requesting a replacement key.

The signal light...
automatically warns of any unexpected power failure. -Slgnal Light /

To replace
If the signal light is not glowing, immediately 0 for power interruption, for an unplugged power cord, l for a burned out signal light. l check:

burned out slgnal Ilght:

I. Unplug power cord from outlet. 2. Open the freezer door. 3. Unplug burned out light and replace with one of same waltage and size. Signal light can be ordered from your WHIRLPOOL dealer, Part No. 1103639. 4. Close freezer door and plug power cord into outlet.

6