WHIRLPOOL EV200NXRW1
Instrukcja Obsługi

Using your freezer
Setting the temperature control...
To stat-l, turn control to the middle of the dial. This setting is designed to maintain the temperature at or near 0°F (- 17.8 �C] under normal operating conditions. II

Adjusting the temperature control.,
1. Turn control to higher number for colder temperatures. 2. Turn to lower number for less cold temperatures.

Cooling freezer first...
I. Allow freezer to cool 6 to 8 hours before filling with

frozen food.
2. Let it cool overnight before adding large amount of unfrozen food. Note: When freezer is first started, the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending on room temperature and the number of times the freezer door is opened. After the cabinet is cooled, the compressor will turn ON and OFF as needed to keep the freezer at the proper temperature.

The Power Saving Control...
operates electric heaters. These heaters help prevent moisture from forming on the outside of the freezer when humidity is high. I, Use the OFF setting when humidity is low. 2. Use the ON setting only if moisture forms on the outside of the freezer. I,<..,.,; II.j -,..

Changing the light bulb...
WARNING: To avoid possible shocks, first unplug freezer or turn off electricity leading to freezer at the main power supply.
1. Remove light shield by pulling away from the side wall. 2. Replace bulb with a 40-w& appliance bulb. 3. Replace the light shield. Insert the shield tabs in the wall slots, then press the shield to snap into place. 4. Plug in the power cord.

�7rnJr.i

/_..,_iE..rd

PaI*

Removing the bottom basket...
To remove:
1 Lift up on basket. 2. Pull out.
Lift up Then out

To replace:
1. Insert into rear slides. 2. Lower into place. 3. Push basket into place.

To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock. If the key is lost, contact your WHIRLPOOL dealer for a replacement. Always give the complete model and serial number of your freezer when requesting a replacement key. 5