ELECTROLUX EWF1245
Instrukcja Obsługi

132991680 GB.qxd

28/10/2003

13:50

Pagina

19

10. Start the programme
Press the START/PAUSE button. The relevant light will stop flashing. The message relevant to the phase that is in progress will be shown in the display. If you have chosen a delayed start, the washing machine will begin the countdown.

If these requirements are met, when you pause the washing machine, the relevant message appears in the display and the door can be opened. Should it not be possible to open the door, and should it be absolutely necessary to do so, switch the machine off by turning the selector dial on "O" position. After approximately 3 minutes, you can open the door. Pay attention to the level and temperature of the water in the washing machine!

COTTON Washing 40°C
Temp.

08.30 12.00

1200
Spin Options Change

Exit

START/PAUSE

14. End of programme
At the end of the programme, the washing machine stops automatically, gives an audible signal (if option no sound has not been selected), and displays the relevant message. If you had selected the RINSE HOLD or NIGHT CYCLE option, the START/PAUSE button light is off. To drain or spin first turn the programme selector dial to «O» and then to drain programme or spin/delicate spin programme /. Release of the lock is also indicated by the coming on of the message "Door openable" (cycle ended). Turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the washing machine. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e.g. by shrinking) or bleed colour into another load of laundry. We advise you to close the water supply tap and disconnect the plug from the socket. Leave the door ajar in order to air the washing machine.

11. How to change a programme during its cycle
Before you make any change, you must pause the washing machine by pressing the START/PAUSE button. It is possible to change any phase before the programme carries it out. When the programme has started, you can only reset it by turning the programme selector dial to «O» and then you can select the new programme. The washing water remains in the tub.Start the new programme by depressing the START/PAUSE button. Note: To drain the water before starting the new cycle you have to cancel the programme and select the DRAIN cycle.

12. Cancelling a programme
Turn the selector dial to «O» to cancel a programme which is running. Now you can select a new programme.

13. How to open the door during the cycle of a programme
You can open the door, after having set the washing machine to PAUSE, provided the following conditions exist:
�

the washing machine is not in the heating phase beyond 55°C; the level of the water is not high; the drum is not turning.

� �

19

ENGLISH