Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 11 (kliknij aby zobaczyć)
This button allows you also to select special programmes, such as RINSES, SPIN and DRAIN. � If the machine is already switched on because it has just performed a washing programme, proceed as follows: - depress RESET once or repeatidly to cancel the previously performed programme (three blinking dashes will appear on the display); - select the type of fabric by means of the relevant button; - select the special programme: � RINSES Depress RESET once, the pilot light WASH goes out. � SPIN Depress RESET twice, the pilot lights WASH and RINSES go out. � DRAIN Depress RESET three times, the pilot lights WASH , RINSES and SPIN go out. Example: In this case the machine will perform the rinses and spin.
If you have already pressed the START/PAUSE button, and you wish to change or cancel the delay time, proceed as follows: � set the washing machine to PAUSE by pressing the START/PAUSE button; � press the DELAY button until the display shows the desired delay time or � press the DELAY button once, to erase the delay time. The display will indicate �0h�. � press the START/PAUSE button again. Important! The door will be locked throughout the delay time (DOOR LOCKED light lit). If you need to open the door, you must first set the washing machine to PAUSE by pressing the START/PAUSE button. After you have closed the door, press the START/PAUSE button again.
12 Programme phase indicator lights
When you select a programme, the lights relevant to the phases that form the programme light up.
� If the machine is switched off: - depress ON/OFF button to switch it on; - select the type of fabric by means of button FABRIC: - select the special programme as previously described. After you have started the programme, only the light relevant to the phase that is currently being carried out will remain lit.
11 DELAY button
This button makes it possible to delay the starting of the programme by up to 24 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears. You must select this option after you have set the programme and before you press the START/PAUSE button. The time value shown on the display will decrease by one unit every hour. You can change the delay time at any moment, before you press the START/PAUSE button. 11
