Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 15 (kliknij aby zobaczyć)
10. Changing an option or a programme during its cycle
+
It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the START/PAUSE button. Changing a running programme is possible only by resetting it. Turn the programme selector dial to O and then to the new programme position. The washing water in the tub will not emptied out. Start the new programme by depressing the START/PAUSE button.
8. Select the DELAY START option
To delay starting of a programme, press the DELAY START button. The figures corresponding to the selected delay will be displayed for about 3 seconds, after which the duration of the selected programme will appear on the display.
11. Interrupting a programme
Depress the START/PAUSE button to interrupt a programme which is running, the corresponding light starts to flash. Depress the same button again to restart the programme.
12. Opening the door after the programme has started
First set the machine to PAUSE by pressing the START/PAUSE button. If the door does not open, this means that the machine is already heating, that the water level is above the bottom edge of the door or that the drum is turning. If you cannot open the door but you need to open it you have to switch the machine off by depressing the ON/OFF button . After about 3 minutes the door can be opened (pay attention to the water level and temperature!). To restart the programme depress ON/OFF button again after closing the door.
9. Start the programme
To start the selected programme, press the START/PAUSE button; the corresponding light stops flashing.
13. At the end of the programme
The machine stops automatically. If the Rinse hold or Night cycle option has been selected the porthole remains blocked, the light of the START/PAUSE button goes out, the pilot lights and remain lit, to indicate that the water must be emptied out before opening the door. The display shows a flashing zero. Turn the programme selector dial to Reset O and press ON/OFF button to switch the machine off . Remove the laundry from the drum and carefully check that the drum is empty so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 15
The pilot light corresponding to the wash phase which is running is on. The machine starts operating. If you have selected the delayed start the machine starts its countdown. The display shows the delay or the duration of the programme. During this period it is possible to load other laundry: � depress START/PAUSE button; � load the laundry; � close the door and depress START/PAUSE button again.
