Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 20 (kliknij aby zobaczyć)
Replacing
1. Make sure all surface units are off and cool before replacing surface units and reflector bowls.
2. Line up openings in the reflector bowl with the surface unit receptacle and the element hold-down clip.
3. Hold the surface unit as level as possible with the terminal just started into the receptacle. Push the surface unit terminal into the receptacle.
4. When terminal is pushed into the receptacle as far as it will go, push down the edge of the surface unit
opposite the receptacle. The element hold-down clip will keep the surface unit from moving around.
NOTE: Reflector bowls reflect heat back to
the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer. If a reflector bowl gets discolored, some of your utensils may not be flat enough, or some may be too large for the surface unit. In either case, some of the heat that�s meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.
