Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 5 (kliknij aby zobaczyć)
Water drainage
The end of the drain hose can be positioned in three ways: Over the edge of a basin at a height of between 60 and 90 cm. To keep the drain hose spout bent, use the special plastic hose guide supplied with the machine. Secure it to the wall with a hook, for example, or to the tap by means of a piece of string, to prevent the drain hose moving during rinsing
Electrical connection
Before plugging the appliance into the wall socket, make sure that: 1. the mains voltage corresponds to the voltage given in the technical specifications; 2. the meter, fuses, mains power supply and wall socket can all take the maximum load required. Make sure that the socket and plug are compatible without having to use any type of adapter. If necessary, have the domestic wiring system socket replaced. The electric cable must not be extended. If it is too short and you do not wish to move the socket, replace it completely with a longer cable. Safety standards require the appliance to be earthed. The Manufacturer accepts no liability for failure to observe the above safety precautions.
P0235
cycle thus causing floods. In a basin drainpipe branch: the branch must be above the basin siphon so that the end of the hose is at least 60 cm from ground level. Directly in a drainpipe: you are advised to use a vertical 65 cm high pipe; in any case it should never be shorter than 60 cm or longer than 90 cm. The end part of the drain hose must always be ventilated, i.e. the internal diameter of the pipe must be wider than the external diameter of the drain hose. The drain hose can be extended up to a maximum length of 180 cm. Use an extension with an internal diameter at least equal to the diameter of the original hose and a suitable fitting. The hose extension will run along the floor and only the part near the drainage point will be raised.
Levelling
Position the appliance and level it by tightening or loosening one or two of the adjustable feet. Ensure that the machine is resting securely with all four feet on the ground. Once the machine has been levelled, tighten up the lock nuts on all feet with the aid of a screwdriver.
