WHIRLPOOL FL 5105
Instrukcja Obsługi

3gb10001.fm5 Page 115 Wednesday, September 5, 2001 5:17 PM

REMOVING THE FILTER
1. Switch off the appliance and drain the water (see next paragraph �Draining residual water�). 2. Open the filter cover with a coin. 3. Place a tray or container beneath the cover. 4. Slowly turn the filter anticlockwise without unscrewing it completely (using pliers to handle the filter grip makes screwing easier). 5. Wait until all the water has drained off. 6. Now unscrew the filter completely and remove it. 7. Remove any foreign material from the filter. 8. Check that the pump rotor moves freely. 9. Insert the filter and screw it in clockwise firmly until it locks. 10. Pour 1/2 litre of water into the detergent drawer and check that water does not leak from the filter. 11. Close the cover. Check the filter two or three times a year and clean it if necessary. � Check the filter if the appliance is not draining properly or if it fails to perform spin cycles. � Remove the filter if the pump is blocked by an object (buttons, coins, safety pins, etc.). IMPORTANT: Make sure the water has had time to cool before draining the appliance.

2 6

4

DRAINING RESIDUAL WATER
1.Switch off the appliance. 2.Unplug the machine from the mains. 3.Unclip the drain hose connection on the rear part of the machine (see arrow A and B). 4.Place a container in suitable size beside the machine. Note: After a correct draining cycle the residual water amounts about up to 1 litre but there can be up to 20 litres of water in the machine if stopped during a programme and even 40 litres if the pump is blocked. 5.Lower the drain hose into a container and let the water drain. Note: Make sure that the water has cooled before draining. 6.Wait until the flow stops. 7. Fix again the drain hose on the rear side of the machine (see arrow B) otherwise there is the risk of leakage and the normal filling and draining functions of the machine cannot be guaranteed. 8.Replace the drain hose with the �U� bend and fix it. When should I drain residual water? � Before transporting (moving) the machine. � If the appliance is installed in a room subject to sub-zero temperatures. It is best in this case to drain the machine after every wash. 115