Listening to FM and AM Broadcasts
Tuning In a Station
1 When the unit is turned on, press TUNER/BAND to select tuner mode.
The unit tunes in the last station tuned in (either FM or AM).
BAND
Presetting Stations
You can preset 20 FM and 20 AM stations.
TUNER
� There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 Tune in the station you want to preset.
BAND
2 Press TUNER/BAND to select the band, FM or AM.
Each time you press the button, the band selection alternates between FM and AM.
TUNER
� See �Tuning In a Station� on the left.
2 Press PROGRAM.
The PROGRAM indicator and �00� start blinking on the display.
SEARCH/TUNING
PROGRAM
3 Press and hold 4 or ¢ for more than 1 second.
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. If a program is broadcast in stereo, the STEREO indicator lights up. To stop searching, press 4 or ¢.
3 Press PRESET � or 5 (or REPEAT/PRE DOWN or PRE UP on the remote control) to specify the desired preset number.
REPEAT
PRESET
4 Wait a few seconds to confirm the preset number.
� Alternatively, press PROGRAM.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
5 To preset more stations, repeat the steps above, allocating a different preset number to each station.
When a new station is stored The station previously memorized with the same preset number is erased. (The frequency of the new station replaces the previous frequency in memory.)
Tuning In a Preset Station
BAND
1 Press TUNER/BAND to select tuner mode.
TUNER
2 Press TUNER/BAND to select the band, FM or AM. 3 Press PRESET � or 5 (or REPEAT/PRE DOWN or PRE UP on the remote control) to select the desired preset number.
PRESET
