jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 275 (kliknij aby zobaczyć)
31 October 1995
CLEANING
4.4 ENTRANCE SEAL REPLACEMENT
[A] [B] [D] [E] [E]
[E]
[K] [F]
[C] [K]
[L]
1.5±0.5mm
[N]
[G]
[H]
[F]
[I]
[J]
[M]
A173R545.img
1. Remove the cleaning unit and cleaning blade. (See Cleaning Blade Removal.) 2. Remove the used toner. 3. Clean the cleaning unit with a vacuum cleaner. 4. Remove the entrance seal [A] together with the strip of two-sided tape [B] and both of the two-sided seals [C] which secure the entrance seal [A] to the lower casing [D] and the side seals [E]. 5. Clean the lower casing [D] with alcohol. Make sure that no tape remains on the casing surface and the side seals. 6. Place a new strip of two-sided tape [F] on the lower casing surface as shown in the illustration. The side edge [G] of the tape must be flush with the edge [H] of the lower casing and the lower edge [I] of the tape must be flush with the top of the projection [J] of the lower casing as shown in the illustration. 7. Place new strips of two-sided seals [K] on the side seals [E] at both sides. 8. Place the new entrance seal [L] on the two-sided tape [F] and the two-sided seals [K] as shown in the illustration. NOTE: a) The lower edge [M] of the entrance seal must be aligned with the edge [J] of the projection of the lower casing. b) Make sure that there are no waves in the upper edge [N] of the entrance seal.
5-33
