jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
Tekstowy podgląd strony 218 (kliknij aby zobaczyć)
1 December 1990
4.7 ENTRANCE SEAL REPLACEMENT
[A] [B]
[C] [I]
[H]
2.5mm
[F] [G]
[D]
� �
[E]
1. Remove the cleaning unit and the following parts: Cleaning Blade Cleaning Brush 2. Remove the used toner. (See Used Toner Collection.) 3. Clean the cleaning unit with a vaccum cleaner.
4. Remove the entrance seal [A] together with the strip of 2-sided tape securing it to the lower casing. 5. Clean the lower casing [B] with alcohol; make sure that no tape remains on the casing surface. 6. Place a new strip of 2-sided tape [C] on the lower casing surface. The lower edge [D] of the tape must be flush with the edge [E] of the projection as shown in the illustration. 7. Place the new entrance seal on the 2-sided tape. Extend the seal so that both edges [F] align with the edges [G] of the tape. NOTE: a) The lower edge [H] of the entrance seal must be aligned with the edge [E] of the projection on the lower casing. b) Make sure that there are no waves in the upper edge [I] of the entrance seal.
