PHILIPS FTR9952/69C
Instrukcja Obsługi

Display message Switch the TV to standby. The message appears on the screen when the TV is switched on again. If you selected Once, the message will disappear from the screen after about 45 seconds. If you selected Continuous, the message will appear on the screen until the Run menu item in the Message menu is switched to No or until the receiver is powered off. The message does NOT appear when Continuous subtitles have been switched On. See p. 10. Timers With the Timers menu you can make your TV automatically switch to a specific programme number from standby or switch over to a different programme number at a specific time. Do not switch off your receiver with the power key A on the receiver ! Actual time If you have installed a TV channel which also broadcasts teletext on programme number 1 or under the lowest favourite programme number greater than 1, the time is downloaded from that TV channel. If this is not the case you have to set the time manually with the digit keys. The time, (entered manually) is updated every minute and remains until the TV is switched off with the power key A. Note: If you entered an incorrect digit, complete the actual time with arbitrary numbers, then start again. Use 24 hour, or military time. Programme Enter with the digit keys the programme number of the TV channel you want your TV to switch over to. Use 24 hour, or military time ! Start time Enter with the digit keys the start time of the selected TV programme number you want your TV to switch over to. Use 24 hour, or military time ! Cancel timer Select Cancel Timer and press OK to reset the Start time to --:--

TIMERS

Actual Time Programme Start Time Cancel Timer

Keys in front of the receiver box
Should your remote be lost or broken you can still browse through the TV channels and A/V sources or change some of the basic picture and sound settings with the keys in front of the receiver box. The PROGRAM - and + keys enable you to select the TV channels or A/V sources. The VOLUME - and + keys enable you to adjust the volume. Note: If the message Child Lock ON appears, the child lock must be switched off (with a remote control) before you can use the PROGRAM - and + or the VOLUME - or + keys on the receiver. See p. 14.
LOCAL PROGRAM MENU VOLUME

Press the LOCAL MENU key behind the door at the front of the receiver repeatedly to select Volume, Brightness, Colour, Contrast, Treble or Bass. Press the VOLUME - or + key to adjust the chosen selection. The selected adjustment automatically switches off when after 10 sec. no action has been executed.

Use of the menus

15