Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
PREPARATION
INSERTING BATTERIES IN THE REMOTE CONTROL
1 2 3
Remove the back cover
Press and slide the back cover to remove.
Insert batteries
Insert batteries with shown below. and as
Close the back cover
About the batteries
� The battery life is about 1 year. � Replace the batteries when the remote control becomes inoperative. � Incorrect usage of the batteries may cause battery fluid leakage and/or damage. Take care of the following when handling: � When replacing the batteries, replace both batteries with new ones of the same type. (Use R6(AA) manganese batteries (2 units).) � When not using the unit or remote control for an extended period, remove the batteries. This prevents malfunction of the remote control from battery fluid leakage. *The batteries of the accessory are for initial use only and may be depleted within 1 year.
USING THE REMOTE CONTROL
� Operate the remote control facing the main unit (Receiver). � The signal range is about 7m (front). � Make sure there are no objects blocking the path of the signal.
Receiver Transmitter
NOTE
� Avoid strong impact on the remote control. In addition, do not wet the remote control or place it under direct sunlight or near a stove, etc., otherwise a malfunction may occur.
