Operation:
Insert a 9V battery (2) or connect a regulated 9V power supply adaptor to the DC jack (4). Connecting an instrument to the input jack (3) will automatically switch the unit on. Connect your amplifier to the output jack (6). Select your desired sound with the 3 control knobs (7, 8, 9). (see Sound examples) Pressing the pedal (1) switches the unit on or off. Instead using this unit on the frontstage, you can place it with your equipment and control it with a standard momentary footswitch connected to the remote jack (5). Before changing the battery (2) always unplug the input jack (3) to switch the unit off. We suggest to use a regulated 9V power supply adaptor to keep our environment clean. Power supply specifications: see imprint on bottom of unit. - Thank you.
FU-Z
Specifications
Power Consumption Input impedance Output impedance Max. input Controls Jacks Remote Display Dimensions Weight 9V dry battery / AC adaptor max. 10mA 1Mohm 2Kohm +6dBm GAIN, TONE, LEVEL Input, DC, Remote, Output momentary switch green LED indicator 74mmx126mmx58mm 450g (without Battery)
KTA 980410-0440
-
Important notes:
Avoid using this unit in extreme humidity, heat or dust environment. When the unit is not in use for longer periods, remove the battery (2) to prevent damages by battery leakage. Also unplug the input (3) to prevent wasting battery life when the unit is not in use.
Specifications are subject to change without notice!
Sound Examples:
GAIN
TONE
LEVEL
Function:
(3) IN jack: Inserting a plug switches the unit on. (4) 9V DC jack: Connect a regulated 9V power supply unit. (5) REMOTE jack: The ON / OFF-function can be remote controlled by a momentary switch, connected to the REMOTE jack (5). Intelligent switching devices (like the Nobels MS-4 or MF-2) also can remote control the unit.
-1 Rhythm
-2 Jimmy's Style
(6) OUT jack: This output delivers a low impedance signal best for the input of your amplifier. (7) GAIN Regler : This control adjusts the amount of the FUZZ effect. Turning the pot to the right increases the drive and adds more and more overtones to the signal.
-3 Full Throttle
(8) TONE Regler: This control adjusts the amount of high frequencies. Right position = max. overtones. Left position = very deep sound. (9) LEVEL control: Adjusts the volume. Attention: It might be VERY loud!
-4 Solo
(10)LED: This Led shows the state of the effect. LED on = Effect on.
