PHILIPS FW358C3799
Instrukcja Obsługi

RECORDING
Dubbing tapes (from tape deck 1 to tape deck 2)
1 Press TAPE to select tape deck 2 . 2 Load the prerecorded tape into tape deck 1 and a blank tape into tape deck 2. � Make sure that the tape in tape deck 1 has its full spool to the left. 3 Press DUBBING once for normal speed dubbing or twice within 2 seconds for high speed dubbing. � "NORMAL" (normal speed) or "FAST" (high speed) will be displayed and then followed by "DUBBING". � HSD flag appears on the display for high speed dubbing. � Dubbing will start immediately. � REC flag starts flashing. 4 Press STOP � to stop dubbing.

CLOCK
1 Load a blank tape into tape deck 2 and a disc into the disc tray. 2 Press CD to select CD mode . � You can program the tracks in the order you want them to be recorded (see Programming Tracks). If not, the tracks are recorded according to the selected disc. 3 Press RECORD to start recording. � REC flag starts flashing. � CD will start playback automatically. 4 Press STOP � to stop recording. You can view the clock (if it is set) at standby or any source mode. It will be displayed for about 7 seconds. � Press CLOCK�TIMER briefly. � �10:25� (the current time) will be displayed. � �--:--� will be displayed if the clock is not set.

Clock Setting
The clock is set in 24-hour mode, e.g. �00:00� or �23:59�. Before setting the clock, you must be in the View Clock mode. 1 Press CLOCK�TIMER to select clock mode. � �00:00� or the current time starts flashing. � �à , á , í , ë, � light up. � 2 Set the hour with à or á. 3 Set the minute with í or ë. 4 Press CLOCK�TIMER again to store the setting. � The clock starts running. � To exit without storing the setting, press STOP �.

Recording from other sources (only on tape
deck 2)
1 2 � 3 Load a blank tape into tape deck 2. Press CD, TUNER or AUX. Start playback of the selected source. Press RECORD to start recording. � REC flag starts flashing. 4 Press STOP � to stop recording.

Notes: � At the end of side A, flip the tapes to side B and repeat the procedure. � Dubbing of tapes is only possible from tape deck 1 to tape deck 2. � To ensure good dubbing, use tapes of the same length. � During high speed dubbing in Tape mode, the sound is reduced to a low volume. � You can switch to other source while dubbing.

Note: � During recording, it is not possible to listen to another sound source.

Notes: � During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically. � When a power interruption occurs, the clock setting is erased. � To set the time with RDS clock, see "Receiving RDS Radio Station" under TUNER section.

21

Untitled-26

21

6/15/00, 4:52 PM

3139 116 17942

English

CD Synchro Start Recording

View Clock