PHILIPS FW-C55/25
Instrukcja Obsługi

CLOCK
MINI HIFI SYSTEM
PROGRAM SHUFFLE REPEAT TIMER REC NEWS T.A. AM MW FM LW
60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz

TIMER
STEREO BACK FRONT HSD

5 Press CLOCK/TIMER again to store the setting. � The clock starts.
DOLBY B NR RDS

STANDBY ON

� To exit without storing the setting, press � on the system.

CLOCK/ TIMER

NEWS/TA

CD1 � 2 � 3 CD
PROG
SEARCH � TUNING

BAND TUNER
STOP�CLEAR

TAPE 1 � 2 TAPE
PLAY PAUSE

CDR/VIDEO AUX
PREV SIDE NEXT
v

PRESET v

A. REV

DU (HSD B )

REC
MIC

INCREDIBLE

SOUND NAVIGATION
BOOST

DYNAMIC BASS

MIC LEVEL

Notes: � During clock setting, if no button is pressed within 90 seconds, the system will exit clock setting mode automatically. � When a power interruption occurs, the clock setting is erased. � To set the time with RDS clock, see "Receiving RDS Radio Station" under TUNER section.

SURROUND

DIGITAL SOUND CONTROL

View Clock
You can view the clock (if it is set) if the system is in Standby mode or when any sound source is selected (CD, TUNER, etc.). The clock will be displayed for about seven seconds. � Press CLOCK/TIMER briefly. � "PM 10:38 or 22:38" (the current time) will be displayed depending on whether you have selected 12- or 24-hour mode. � "--:--" will be displayed if the : clock is not set.

Clock Setting
The clock can be set in either 12- or 24hour mode, e.g. "AM 12:00" or "00:00". Before setting the clock, you must be in the View Clock mode. 1 Press CLOCK/TIMER to select clock mode. 2 Press PROG (on the system only) to select 12- and 24- hour mode. � If 12-hour mode is selected, "AM 12:00" starts flashing. � If 24-hour mode is selected, "00:00" starts flashing. 3 Set the hour with à or á on the system. 4 Set the minute with í or ë on the system.

Timer Setting
� The system can switch on to CD, TUNER, or TAPE 2 mode automatically at a preset time. It can serve as an alarm to wake you up. � Before setting the timer, make sure the clock is set correctly. � The timer will always be switched on once it is set. � The volume of the timer will increase from the minimum level until the volume level before the set is switched to standby mode.

1 Press and hold CLOCK/TIMER for more than 2 seconds to select timer mode. � "AM 12:00" or "00:00" or the last timer setting starts flashing depending on whether you have selected 12- or 24-hour mode. � The TIMER starts flashing. � The selected source is lit while other available sources are flashing. 2 Press CD, TUNER or TAPE to select the desired source. � Before selecting CD or TAPE, make sure a CD or tape is loaded in the CD tray or tape deck 2. 3 Press à or á on the system to set the hour for the timer to start. 4 Press í or ë on the system to set the minute for the timer to start. 5 Press CLOCK/TIMER to store the start time. � The timer is now set. � The TIMER remains on the display. � At the preset time, the timer will be activated. � The selected source will be played.

Notes: � During timer setting, if no button is pressed within 90 seconds, the system will exit timer setting mode automatically. � If the source selected is TUNER, the last tuned frequency will be switched on.

pg 01-26/C55-C58/34-En

23

2/22/00, 7:02 PM

3139 116 19541

English
23