TAPE
3a(for playback on tape deck 2 only) � Press à or ë to select tape side (see Tape Side). � Press A. REV to select the different type of playback mode (see Auto Reverse Playback). 4 Press � to end playback. � "T1 or T2" with "! ! ! or @ @ @" will be displayed. Note: � When the tape has stopped playing, the system will switch to standby mode after 30 minutes if no button is pressed.
During playback � Press and hold à or á until the desired passage is located. � "T1 or T2" with "! ! or @ @" scrolling left or right will be displayed depending on which button is pressed. � During searching, the sound is reduced to a low volume. � When you release à or á, the tape continues playing.
System
1 Press DOLBY B NR to switch on Dolby B NR. � The d B NR appears in the display. 2 Press DOLBY B NR again to switch off Dolby B NR. � The d B NR disappears from the display. Note:
Rewind/Fast Forward
When playback is stopped 1 You can rewind or fast forward the tape by pressing à or á respectively. � If rewinding, "T1 ! or T2 !" with "!" scrolling left will be displayed. � If fast forwarding, "T1 @ or T2 @" with "@" scrolling right will be displayed � The tape will stop automatically at the end of the rewinding or fast forwarding. 2 Press � to stop rewinding or fast forwarding.
Notes: � During rewinding or fast forwarding of a tape, it is also possible to select another source (e.g. CD, TUNER, or AUX). � Before playing a tape, check and tighten slack tape with a pencil. Slack tape may get jammed or may burst in the mechanism. � C-120 tape is extremely thin and is easily deformed or damaged. It is not recommended for use in this system. � Store the tapes at room temperature and do not put them too close to a magnetic field (for example, a transformer, TV, or speaker).
� A tape recorded with the Dolby B NR system should also be played in the Dolby B NR mode. If you forget to operate the DOLBY B NR button, the treble may be reproduced too strongly. .
