PHILIPS FWM570/19
Instrukcja Obsługi

Tuner Operations
IMPORTANT! Make sure the FM and MW antennas are connected.

2

Tuning to radio stations 1 2
Press TUNER to enter tuner mode. To select another waveband (FM or MW), press TUNER again. Press and hold 4 or ¢ (or 1 / ¡ on the remote control) until the frequency indication starts to change, then release. � The system automatically tunes to the next strong signal radio reception.

Press � on the main unit to start installation. � � �INSTALL TUNER� is displayed. � All previously stored radio stations will be replaced. � Once completed, the last tuned radio station will be played. Automatic presetting You can start the automatic presetting from a selected preset number.

1 2

In tuner mode, press � or + (or í/ë on the remote control) to select a preset number. Press and hold PROGRAM until �AUTO� is displayed. � If a radio station has been stored in one of the presets, it will not be stored again under another preset number. � If no preset number is selected, automatic preset will begin from preset (1) and all your former presets will be overridden. Manual presetting You can choose to store only the favourite radio stations.

For tuning to a weak signal station, � Press 4 or ¢ (or 1 / ¡ on the remote control) briefly and repeatedly until an optimal reception is found.

Presetting radio stations
You can store up to 40 preset radio stations in the memory, starting from FM and followed by MW bands. Notes: � The system will exit presetting mode if no button is pressed within 20 seconds. � If no stereo frequency is detected during Plug and Play, �CHECK ANTENNA� is displayed. Using the Plug and Play (page 3 - P3) Plug and Play allows you to store all available radio stations automatically.

1 2

Tune to your desired radio station (refer to �Tuning to radio stations�). Press PROGRAM. � The preset number starts flashing. If you want to store the radio station in another preset number, press � or + (or í/ë on the remote control).

3

Press PROGRAM again to store. � Repeat steps 1�3 to store other radio stations.

1

Connect the system to the power supply, �AUTO INSTALL - PRESS PLAY� is displayed. OR In the Standby mode, Press and hold � on the main unit until � �AUTO INSTALL - PRESS PLAY� is displayed.

19

English