PHILIPS FW-P73/37
Instrukcja Obsługi

24

RECORDING
Dubbing tapes (from tape deck 2
to tape deck 1) 1 Load the prerecorded tape into tape deck 2 and a blank tape into tape deck 1. � Make sure both tapes have their full spool to the left. 2 Press PAUSE on tape deck 1. 3 Press RECORD on tape deck 1. 4 Press PLAY� on tape deck 2. � The REC starts flashing. � Recording will start automatically. 5 Press STOP�OPEN on tape deck 1 and tape deck 2 to stop dubbing. Notes: � At the end of side A, flip the tapes to side B and repeat the procedure. � Dubbing of tapes is only possible from tape deck 2 to tape deck 1. � To ensure good dubbing, use tapes of the same length.

CLOCK
MINI HIFI SYSTEM
PROGRAM SHUFFLE REPEAT TIMER REC NEWS T.A. AM MW FM LW
60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz

Recording from other sources (only on tape deck 1)
Load a blank tape into tape deck 1. Press CD, TUNER or AUX. Start playback of the selected source. Press RECORD on tape deck 1 to start recording. � The REC starts flashing. 4 Press PAUSE to interrupt recording. 5 Press STOP�OPEN on tape deck 1 to stop recording. Note: � During recording, it is not possible to listen to another sound source. 1 2 � 3
STANDBY ON CLOCK/ TIMER

STEREO BACK FRONT HSD

C
L PRO LOGIC R
DOLBY B NR RDS NEWS!

S

S

CD1 � 2 � 3 CD
SEARCH � TUNING

FM � AM TUNER

TAPE 1 � 2
v

VIDEO AUX

PROG

TAPE

STOP � CLEAR PLAY PAUSE

PREV

PRESET v NEXT

UP

SOUND
DOWN

SOUND NAVIGATION DIGITAL SOUND CONTROL DYNAMIC BASS BOOST

VOLUME

View Clock
You can view the clock (if it is set) if the system is in Standby mode or when any sound source is selected (CD, TUNER, etc.). The clock will be displayed for about seven seconds. � Press CLOCK/TIMER briefly. � �PM 10:38 or 22:38 � (the current time) will be displayed depending on whether you have selected 12- or 24-hour mode. � �--:--� will be displayed if the : clock is not set.

Clock Setting
The clock can be set in either 12- or 24-hour mode, e.g. �AM 12:00� or �00:00�. Before setting the clock, you must be in the View Clock mode. 1 Press CLOCK/TIMER to select clock mode. 2 Press PROG (on the system only) to select 12- and 24- hour mode. � If 12-hour mode is selected, �AM 12:00� starts flashing. � If 24-hour mode is selected, �00:00� starts flashing. 3 Set the hour with à or á on the system. 4 Set the minute with í or ë on the system. 5 Press CLOCK/TIMER again to store the setting. � The clock starts. 3139 116 19511 ( ENG)