Tape Operation/Recording
To change the playback side on tape deck 2 only G Press à or ë. � The A (BACK) or B (FRONT) appear on the display, depending on the tape side selected. To change the playback mode on tape deck 2 only G Press AUTO REVERSE repeatedly to select the different playback modes. å : playback on one side of the tape only. � : both sides are played once. � : both sides are played repeatedly, up to 10 times each side unless you press�. To rewind or fast forward during playback G Press and hold à or á until the desired passage is reached, then release. � The tape continues playing. G The tape will stop automatically at the end of the rewinding or fast forwarding. � During searching, the sound is reduced to a low volume. To rewind or fast forward when playback is stopped Press à or á. Press � when the desired passage reached. Note: � During rewinding or fast forwarding of a tape, it is also possible to select another source (CD, TUNER or AUX for example). IMPORTANT! � Recording is permissible insofar as copyright or other rights of third parties are not infringed upon. � Recording is possible only on tape deck 2. � Switch off Dolby Pro Logic when recording.
General Information on Recording
G For recording, use only tape of IEC type I (normal tape) or IEC type II (Cr02). G The recording level is set automatically, regardless of the position of the Volume, VEC, DSC and so forth. G The tape is secured at both ends with leader tape. At the beginning and end of the tape, nothing will be recorded for six to seven seconds. G To prevent accidental recording, break out the tab on the left shoulder of the tape side you want to protect. G If �CHECK TAPE� is displayed, the protection tab has been broken. Put a piece of clear adhesive tape over the opening. Do not cover the Cr02 tape detection hole when covering the tab opening.