ZOOM G2
Instrukcja Obsługi

Selecting a Patch

Selecting a Patch
To try out the various effects of the G2, we recommend that you simply play your instrument while switching patches.

Adjust tone and volume
To adjust the effect sound and volume levels in play mode, the Parameter knobs 1 � 3 can be used. Each knob controls a specific parameter.
Parameter knob 1 Parameter knob 3

Turn power on
Use a monaural shielded cable to connect the guitar to the [INPUT] jack of the G2. When using the G2 with the AC adapter, plug the adapter into the outlet and plug the cable from the adapter into the [DC IN] jack on the G2. Set the [POWER] switch on the rear panel of the G2 to ON. Turn the guitar amplifier on and adjust the volume to a suitable position.

Adjusts the GAIN parameter of the DRIVE module (mainly distortion depth).

Adjusts the PATCH LEVEL parameter (output level of the entire patch).

Parameter knob 2

Adjusts the TONE parameter of the DRIVE module (mainly distortion sound character).

Set the G2 to play mode
If the Module selector is set to a position other than "PLAY", set it to "PLAY".
The bank and patch that were selected when the power was last turned off will appear on the display.

When you turn a Parameter knob, the corresponding LED lights up and the display briefly shows the current value of the respective parameter.

A1
Bank name Patch number

NOTE � If the DRIVE module is set to OFF for
the currently selected module (display shows "oF"), Parameter knobs 1 and 2 have no effect. � Changes made here are temporary and will be lost when you select another patch. To retain the changes, store the patch in the user area. � The master level in common to all patches is set in edit mode (� p. 30).

HINT

Immediately after turning the G2 on, the unit will be in play mode, even if the Module selector is set to a position other than "PLAY".

Select a patch
To switch the patch, press one of the [W]/[Q] foot switches.
Pressing the [W] foot switch calls up the next lower patch, and pressing the [Q] foot switch calls up the next higher patch. Repeatedly pressing one foot switch cycles through patches in the order A0 � A9 ... d0 � d9 � 00 � 09 ... 30 � 39 � A0, or the reverse order.

Directly selecting a bank
To select the banks A � d, 0 � 3 directly, use the BANK [-]/[+] keys.
Pressing the BANK [-] key calls up the next lower bank, and pressing the BANK [+] key calls up the next higher bank.

8

ZOOM G2

ZOOM G2

9