PHILIPS GC2520/37
Instrukcja Obsługi

EnglISh
Preparing for use Filling the water tank 1 Remove the mains plug from the wall socket. 2 Set the steam control to position O (= no steam) (Fig. 2). 3 Open the cap of the filling opening. 4 Tilt the iron and fill the water tank up to maximum level (Fig. 3). If the tap water in your area is very hard, we advise you to use distilled water. Do not use chemically descaled water. Do not fill the water tank beyond the MAX indication.

7

Do not put perfume, vinegar, starch, descaling agents, ironing aids or other chemicals in the water tank. 5 Close the cap of the filling opening (�click�). Setting the temperature , The iron may give off some smoke when you use it for the first time. This will cease after a short while.

1 Put the iron on its heel and set the temperature dial to the required ironing temperature by turning it to the appropriate position (Fig. 4). - Check the laundry care label for the required ironing temperature. - 1 Synthetic fabrics (e.g. acrylic, viscose, polyamide, polyester) - 1 Silk - 2 Wool - 3 otton, linen C - If you do not know what kind or kinds of fabric an article is made of, determine the right ironing temperature by ironing a part that will not be visible when you wear or use the article. - Silk, woollen and synthetic materials: iron the reverse side of the fabric to prevent shiny patches. Avoid using the spray function to prevent stains. 2 Put the mains plug in an earthed wall socket. 3 When the temperature light has gone out, wait a while before you start ironing. Note:The temperature light will go on from time to time during ironing. using the appliance Steam ironing Make sure that there is enough water in the water tank. 1 Set the temperature dial to the recommended position (see section �Setting the temperature�). 2 Set the steam control to the appropriate steam position (Fig. 2). - ç for minimum steam (temperature settings 2 and 3). - é for maximum steam (temperature settings 3 to MAX). Note:The iron will start steaming as soon as the set temperature has been reached. gC2640/gC2620/gC2530/gC2528/gC2520/gC2510 only: Water may leak from the soleplate if the set temperature is too low (MIN to 2).