ZOOM GFX-5
Instrukcja Obsługi

Other Functions

Other Functions

8.

To turn hold delay on, push the expression pedal all the way down.

once more, or until two seconds have elapsed. After recording ends, loop playback starts automatically.

11.

The [ASSIGN] key LED stops �ashing and stays constantly lit, indicating that the unit is in the recording standby condition. The display shows �STOP�.

To turn hold delay off, push the expression pedal once more all the way down.

HINT
For patches where SAMPLER is selected as control target, the sampler function can be turned on and off by fully depressing the expression pedal (� p. 21).

Loop playback Effect sound Original sound

The unit returns to play mode.

Using the sampler function
The GFX-5 incorporates a sampler function that allows recording the input signal in the internal memory. This can be used to record a phrase from a guitar connected to the [INPUT] jack or the sound from an external source such as a CD or MD player connected to the [AUX IN] jack. The maximum recording duration is six seconds. A recorded phrase can also be played back at a slower speed without changing the pitch. This is convenient for example to copy an up-tempo phrase from a CD.

3.

STOP
9.
While playing your guitar, press the foot switch [3] to start recording.

bring up the indication �GT� or �AUX� on the display.
GT/AUX is the parameter for selecting the sampling input source. By turning the [VALUE] dial, you can toggle between the two settings. � GT Signal at [INPUT] jack is sampled. � AUX Signal at [AUX IN] jack is sampled.

To select the input source for sampling, use the PARAMETER [Q]/[W] keys to

Foot switch [3]

Foot switch [2]

The indication �REC� is shown on the display. The actual operation depends on the TIME parameter and MODE parameter.
� TIME parameter set to a numeric value Recording starts as soon as you push the foot switch [3] and continues for the duration set with the TIME parameter. After recording ends, loop playback starts automatically.
Loop playback Effect sound Original sound TIME parameter

� TIME parameter set to �Mn� and MODE parameter set to �So� (See below) Everything you play between one press of foot switch [3] until the next time you press the foot switch is recorded in overdub mode. During this time, the display shows �OVRREC�.

NOTE
� While you are using the hold delay function, the patch cannot be switched. To switch to another patch, you must �rst turn hold delay off by pushing the expression pedal all the way down. � While the GFX-5 is in manual mode, the hold delay function cannot be used. If you try to turn hold delay on in this mode, the manual mode is canceled. (The reverse also applies.)

1. 2.

HINT
Connect the input source to the [INPUT] jack or [AUX IN] jack (� p. 7). Turn power to the GFX-5 on and press the [SAMPLER] key in play mode.
� When �GT� is selected, the signal is always sampled after effect processing. When �AUX� is selected, the signal is always � sampled before effect processing. When recording from the [AUX IN] jack, you can minimize noise and distortion by turning the [LEVEL] knob on the rear panel up past the midway point and adjusting the output level of the external source so that the volume is about equal to that of a guitar. In sampler mode, the MOD module and REV module cannot be used. (These modules are automatically turned off.)

The GFX-5 switches to sampler mode and the indication �GT� appears on the display.

Foot switch [3]

Foot switch [2]

10.

GT
To stop playback, press the foot switch [2].

�

� TIME parameter set to �Mn�

Recording starts as soon as you push the foot switch [3] and continues until you press the foot switch
Effect sound Original sound

When playback stops, the recorded contents are automatically erased.

4.

To start sampling, press the foot switch [3] and play the phrase you want to record (or start playback at the external source component).

Rewind

Play/Stop

Record

During sampling, the effect module keys light up in sequence to show the elapsed sampling time. The LED of foot switch [3] is also lit.

NOTE
In sampler mode, the foot switches [1] - [3] operate as shown above. Therefore the patch cannot be changed until the unit returns to the play mode.

Foot switch [3]

Overdub recording

6 seconds

24

ZOOM GFX-5

ZOOM GFX-5

25