|
|
|
Kto jest w sklepie?
Sklep przegląda 5687 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
33
COUNTER R/M
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTE:
You need the optional RM-V20U remote control unit to perform the following procedure.
SELECT MODE
1 2 3
POWER
M-0:12:34
Set the power switch to PLAY.
FIND EDIT-OUT POINT RESET COUNTER
Locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 2 seconds to reset the tape counter, then press for less than 1 second and make sure �M� appears in the viewfinder.
FIND EDIT-IN POINT
Tape Counter Insert editing indicator Viewfinder
4 5 6
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and press PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.
BEGIN INSERT EDITING
Press Recording Start/Stop. When the counter reaches �0:00:00�, editing stops automatically and the camcorder enters the playback mode.
NOTES:
REW PLAY PAUSE AUDIO DUB INSERT
RM-V20U (optional)
� Insert Editing may not work correctly if a blank segment exists in the recorded tape, or if the recording speed was changed. � The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. � To edit onto a tape with the recording safety tab removed, cover the hole with adhesive tape. � Only video signal is recorded in the Insert Editing mode. When the sound is to be recorded, press AUDIO DUB and PAUSE simultaneously after Step 5. When INSERT and PAUSE are pressed simultaneously again, the unit re-enters the Video-signal-only Recording mode. � If the camcorder�s mike is too close to the TV, or if the TV�s volume is too high, whistling or howling may occur.
|
|
|
> |
|
