JVC GR-DF473AG
Instrukcja Obsługi

EDITING
� The system may not work properly depending on the PC or capture board you are using.

EN

55

�USB� appears on the LCD monitor while the PC is accessing data in the camcorder or the camcorder is transferring a file to the PC. NEVER disconnect the USB cable while �USB� is displayed on the LCD monitor since this can result in product damage.

To hear the dubbed sound during playback Set �NARRATION� to �ON� or �MIX�. ( pg. 37, 41)

NOTES:

� Sound is not heard from the speaker during Audio Dubbing. � When editing onto a tape that was recorded at 12-BIT, the old and new soundtracks are recorded separately. � If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas. � If feedback or howling occurs during TV playback, move the camcorder�s microphone away from the TV, or turn down the TV�s volume. � If you change from 12-BIT to 16-BIT in midrecording and then use the tape for Audio Dubbing, it is not effective from the point where 16-BIT recording began. � During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-BIT audio or a blank portion, Audio Dubbing stops. � Audio dubbing is also possible using an optional microphone connected to the MIC connector. � While an optional microphone is connected, the built-in microphone is disabled. � To perform Audio Dubbing with a video unit connected to the camcorder�s AV connector, first set �S/AV INPUT� to �ON� in VIDEO Menu. ( pg. 37, 42) The �AUX� indication appears instead of �MIC�.

Audio Dubbing
The audio track can be customised only when recorded in the 12-BIT and SP modes. ( pg. 38)
� Use the provided remote control. Microphone Connector

Speaker
START/ STOP PAUSE PLAY STOP A.DUB

Stereo Microphone

REW INSERT

1 Play back the tape to locate the point where
editing will start, then press PAUSE (9).

2 While holding A. DUB (D) on the remote
control, press PAUSE (9). The �9D� and �MIC� indicators appear.

3 Press PLAY (U), then begin �narrating�.
Speak into the microphone.
� To pause dubbing, press PAUSE (9).

4 To end Audio Dubbing, press PAUSE (9),
then STOP (8).

ADVANCED FEATURES