,,,, ,,, ,,,, ,,, ,,,, ,,, ,,,, ,,,, ,,,,, ,,,, ,,,,, ,,,, ,,,, ,,,,,
EN23
PIN-UP
Pin-Up mode*
To Record An Image With A Title/Frame . . . .... refer to �Superimposing A Title/Frame� (
To Remove The Shutter Sound . . . .... when you don�t want to hear the shutter sound, set BEEP/TALLY to �OFF� in the System Menu ( pg. 34 � 39). The sound is no longer hard from the speaker.
pg. 69).
FRAME
Snapshot mode with frame*
FULL
Snapshot mode with no frame*
MULTI-4
Multi-Analyser 4
� Even if �MULTI-4� or �MULTI-9� is engaged, Snapshot recording will be performed in the FULL mode during Digital Zoom. However, the flash will not fire. � If Snapshot recording is not possible, �PHOTO� blinks when PHOTO (SNAPSHOT) is pressed. � Even if Programme AE with special effects ( pg. 44, 45) is engaged, certain modes of Programme AE with special effects are disabled during Snapshot recording. In such a case, the icon blinks. � If shooting is not performed for approx. 5 minutes when the Power Switch is set to � � and power is supplied from the battery pack, the camcorder shuts off automatically to save power. To perform shooting again, close the LCD monitor and re-open it. When using the viewfinder, push back it in and pull it out again. � Motor Drive Mode ( pg. 30) is disabled when the Power Switch is set to � �. � To reduce the Red-Eye effect of the subject�s eyes when the flash fires, pg. 32. � When a cable or headphone set is connected to the AV OUT connector, the shutter sound is not heard from the speaker.
NOTES:
MULTI-9
Multi-Analyser 9
*:There is the sound of a shutter closing.