|
|
|
Kto jest w sklepie?
Sklep przegląda 5744 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
� Torque driver Be sure to use to fastening the mechanism and exterior parts because those parts must strictly be controlled for tightening torque. � Bit This bit is slightly longer than those set in conventional torque drivers. � Tweezers To be used for removing and installing parts and wires. � Chip IC replacement jig To be used for replacement of IC. � Cleaning cloth Recommended the Cleaning cloth to wipe down the video heads, mechanism (tape transport system), optical lens surface. � Guide driver (Hexagonal) To be used for mechanism compatibility adjustment. � INF adjustment lens To be used for adjustment of the camera system. For the usage of this tool, refer to the Service Bulletin No. YASB-10035. � INF lens holder To be used together with the Camera stand for operating the Videocamera in the stripped-down condition such as the status without the exterior parts or for using commodities that are not yet conformable to the interchangeable ring. For the usage of this tool, refer to the Service Bulletin No. YASB-10035. � Camera stand To be used together with the INF adjustment lens holder. For the usage of this tool, refer to the Service Bulletin No. YASB-10035. � Light box assembly To be used for adjustment of the camera system. For the usage of this tool, refer to the Service Bulletin No. YASB-10035. � Gray scale chart To be used for adjustment of the camera system. For the usage of this tool, refer to the Service Bulletin No. YASB-10035. � Color bar chart To be used for adjustment of the camera system. For the usage of this tool, refer to the Service Bulletin No. YASB-10035. � Alignment tape To be used for mechanism compatibility adjustment. MC-1 [For NTSC model] MC-2 [For PAL model] � PC cable To be used to connect the Videocamera and a personal computer with each other when a personal computer is used for adjustment. QAM0099-001 [For J* model] QAM0099-002 [For U* and K* models] QAM0099-003 [For E* models] QAM0099-005 [For A* models] � Communication cable Connect the Communication cable between the PC cable and Jig connector cable when performing a PC adjustment.
� Service support system To be used for adjustment with a personal computer. Software can be downloaded also from JS-net. � Jig connector cable Connected to CN for Jig of the circuit board and used for electrical adjustment, etc. � Extension connector Connect this extension connector to the connector of the Jig connector cable for extending the cable connector.
3-2
|
|
|
> |
|
