Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 23 (kliknij aby zobaczyć)
A Tour of the GRIP
GAIN REDUCTION LED Meter
The red LED meter displays the amount of gain reduction applied by the bass limiters. An increase in gain reduction � by turning the BASS DRIVE Knob clockwise - will cause the meter to light from right to left.
4
BASS LEVEL Knob
This knob adjusts the level of the frequencies that fall below the crossover point set by the XOVER knob, except for the sub-bass.
BASS LEVEL LED Meter
This meter indicates the level of the GRIP�s main output signal. As you increase the level by turning the BASS LEVEL knob clockwise, this meter lights amber from left to right.
LO CUT Knob
This adjusts the cutoff frequency of a steep (6-pole) highpass filter, effectively limiting the lowest frequencies that the GRIP can output. The unit will output only those frequencies that are higher than the one set with the LO CUT knob. This knob is useful for protecting your speakers from ultra-low frequencies that may cause damage.
OUTPUT Knob
This knob controls the level of the GRIP�s total output signal from both the bass and sub-bass channels.
BYPASS Button
When you activate this button, the audio signal bypasses the Grip without being processed. This is useful when you want to compare the processed signal with the unprocessed signal. This button lights red when you enter BYPASS mode.
