|
|
|
Kto jest w sklepie?
Sklep przegląda 5892 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
;
...instruction is ok.
...instrukcja jest ok.
Thanks/Dzięki
;
Documentation made available quickly and It is good quality. Thanks.
GX-CD30/30C/130/130C
CD SECTION
Since this CD system incorporates the following automatic adjustment function, when the pickup is replaced, it is necessary to reajust it. Since this CD unit does not need adjustment, the combination of PWB and laser pickup unit is not restricted.
TEST MODE
Start Note While holding down the "STOP" button, move the FUNCTION/POWER switch to "CD". Then, release the "STOP" button and, within 0.5 second, press the PAUSE button. 1. When the CD LID switch is in the OFF position, the unit will be able to enter the test mode. However, playback cannot be performed in this mode. 2. You can only move the pickup. 3. The LCD display should be the same as it is for normal CD operations. 1 2 The use of the "UP/CUE" button will move the pickup to the outermost position. The use of the "DOWN/REVIEW" button will move the pickup to the innermost position. When the "PLAY" button is pressed, the laser will be lit, and when the "STOP" button is pressed, it will be turned off. Playback will also start and stop when these buttons are pressed. a. If the "PLAY" button is pressed while in the stop mode, the laser will simply be turned on at first. b. If the laser is lit and the "PLAY" button is pressed again, playback will start from the current pickup position. c. If the "STOP" button is pressed, playback will stop. When pressed again, the laser will be turned off. 3 Turning the tracking servo on or off. a. Each time the PAUSE button is pressed during playback, the tracking servo will be turned on or off. (Note: If the PLAY button is pressed while in the stop mode, the tracking servo will automatically be turned on.)
Operation
LCD MODE
Start Display While holding down the "STOP" button, move the FUNCTION/POWER switch to "CD". Then, release the "STOP" button and, within 0.5 second, press the PAUSE button.
1
2
3
1 second
1 second
* After the number � has appeared in the display, each time the "UP/CUE" button is pressed, the display will switch in the following order: �, �, and then �.
�9�
|
|
|
> |
|
