Quick instructions
1 Switching on: Hold down the ON button (the KeyCard has to be inserted), the set plays with the pre-adjusted volume. Switching off: Press ON for approximately 1 second. If the set was turned on by pressing ON, the KeyCard can be used for switching the system on and off. Please read the information of chapter �KeyCard�. The set may also be turned off via the vehicle�s ignition (provided that it was connected correspondingly). After the ignition was switched off, a double beep tone reminds you that you should remove the KeyCard before leaving your vehicle. To operate the set when the ignition is switched off (KeyCard is inserted), proceed as follows: Press �ON� after the double beep tone. The set will be turned on. To avoid that the battery goes flat, the system will be turned off automatically after a playback time of one hour. 2 To change the volume: Press VOL+/VOL-. Each time the set is switched on, it will play with the pre-adjusted volume (VOL FIX). You may also change the VOL FIX setting (see chapter �DSC programming�). 3 FMT Press this button to switch between the memory banks I, II, and T (Travelstore). As soon as this button is pressed, the system will automatically switch to FM. Extra function: Store the six most powerful stations automatically with Travelstore: Press FMT until seek tuning starts in the display.
PORTUGUES ESPAG�OL SVENSKA NEDERLAND ITALIANO FRAN�AIS ENGLISH DEUTSCH
4 M�L To change between medium wave (MW) and long wave (LW) frequencies. 5 -dB - for instantly changing the volume Press the -dB button to instantly mute the audio source. The display will then show MUTE. Return to normal volume by pressing either the -dB or the VOL+ button. When pressing VOL-, the normal playback volume is identical to the -dB (muted) volume. To program the mute volume, proceed as follows: � Adjust the desired volume. � Press -dB for approximately 2 seconds (beep tone is released). This volume will then be stored as the mute volume. Extra function: Press this button to store the values set in the DSC menu.
