Bardzo dobra jakość skanu, przystępna cena. Instrukcja serwisowa okazała się przydatna przy "reanimowaniu" dwudziestoparoletniego decka, który teraz pięknie gra :)
Documentation made available quickly and It is good quality. Thanks.
Tekstowy podgląd strony 50 (kliknij aby zobaczyć)
2. ADDITION OF PARTS AND REMOVE PAGE
Page 4
SECTION 1 SERVICING NOTE
ADJUSTMENT OF CAM PHASE
Absorber Cam
Absorber Cam
Boss SW lever Insert the cam so that the boss touches the SW lever at the left shown in the figure. SW lever Boss
Rotate the cam in the arrow direction, and adjust the phase until the boss touches the SW lever shown in the figure.
Note : Set the slider (1) in this location before inserting the cam.
With the phase adjusted, attach the parts using the following procedure. STEP1 Insert the boss of the slider (3) in the groove of the cam. Slider (3) Boss Cam Lever (1) Boss STEP3 Insert the boss of the lever (1) in the hole of the slider (3) and attach. Lever (1) Boss Screw (PTTWH2.6x8)
Hole of slider (3) STEP2 Set the mecha cover to the groove on the slider (3) and attach. Screw (BVTP2.6x8) Screw (BVTP2.6x8) STEP 4 Bend the slider (2) slightly in the arrow direction and attach it by inserting it in the grooves of the guides (L) and (R). Slider (2) Insert these in the groove afterwards. Boss (Four point) Mecha cover Guide (L)
Groove
Insert these in the groove first. Groove of slider (3) Guide (R) Groove
