PHILIPS HP4888/07
Instrukcja Obsługi

ENGLISH
Introduction The Philips Salon Control hairdryers have been specially designed to meet your personal needs, giving you beautiful and shiny hair.The ioniser inside (HP4882/07, HP4882/17 and HP4888/07 only) emits negatively charged ions that surround your hair. Negative ions reduce the build-up of static electricity and help to keep your hair in good condition, making it frizz-free and smooth. This hairdryer offers you a variety of heat and speed settings. In addition, this hairdryer has a Turbo position for an ultra strong airflow and a Cool position for a cool shot.This gives you optimal styling freedom and optimal control over your hairstyle. The ceramic radiant heat element (HP4888/07 only) produces radiant heat for fast drying with added protection. You can visit our website at www.philips.com for more information about this product or any other Philips beauty product. General description
. .

It is recommended to use the Quick-Dry setting only on shower-wet hair and to select the Caring setting when the hair is almost dry in order to reduce the risk of overdrying. � The Caring setting 5 The Caring setting gently dries the hair at a caring temperature (fig. 4).

The Fixation setting 4 � The Fixation setting fixes the style you have created (fig. 5). For long-lasting styling results, set the switch to the Fixation setting and direct the cool airflow at your hair to fix your style. � You can also use the Cool position of the rocker switch to fix your style (fig. 6). 4 HP4882/07, HP4882/17 and HP4888/07 only: Switch the Ion function on or off by means of the Ion slide switch.The Ion indicator light goes on. The ion function reduces frizz and static electricity and is particularly suitable for dry and almost-dry hair. 5 Dry your hair by making brushing movements with the hairdryer at a small distance from the hair (fig. 7). Attachments
.

A Ion indicator light (HP4882/07, HP4882/17 and HP4888/07 only) B Air inlet grille C Ion slide switch (HP4882/07, HP4882/17 and HP4888/07 only) D Temperature slide switch - 6 = Quick-Dry setting - 5 = Caring setting - 4 = Fixation setting E Airflow slide switch - O = off - I = gentle airflow especially intended for styling - II = strong airflow for quick drying F Hanging loop G Rocker switch - ÷ = Turbo - m = Off - � = Cool H Concentrator I Volume diffuser (HP4882/17 only) J Ceramic radiant heat element (HP4888/07 only). Important Read these instructions for use carefully before using the appliance and save them for future reference. � � � � When travelling, check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance. Check the condition of the mains cord regularly. Do not use the appliance if the plug, the cord or the appliance itself is damaged. If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. Keep this appliance away from water! Do not use this product near or over water contained in baths, washbasins, sinks etc.When used in a bathroom, unplug the appliance after use since the proximity of water presents a risk, even when the hairdryer is switched off. For additional protection, we advise you to install a residual current device (RCD) with a rated residual operating current not exceeding 30mA in the electrical circuit supplying the bathroom.Ask your installer for advice. Keep the appliance out of the reach of children. Never block the air grilles. If the appliance overheats, it will switch off automatically. Unplug the appliance and let it cool down for a few minutes. Before you switch the appliance on again, check the grilles to make sure they are not blocked by fluff, hair, etc. Always switch the appliance off before putting it down, even if it is only for a moment. Always unplug the appliance after use. Do not wind the mains cord round the appliance. HP4882/07, HP488/17 and HP4888/07 only:You may notice a characteristic odour when using this hairdryer.This is caused by the ions that are generated and it is not harmful to the human body. Never use any accessories or parts from other manufacturers or that have not been specifically advised by Philips. Do not insert metal objects into the air grilles in order to avoid electric shock. Using the appliance Drying 1 Put the plug in the wall socket. � 2 Switch the appliance on by selecting the desired airflow setting: Set the slide switch to airflow setting II for ultra-quick drying. Set the slide switch to airflow setting I for drying short hair or styling your hair. You can also use the Turbo position of the rocker switch for an extra powerful airflow (fig. 2). 3 Set the temperature slide switch to the Quick-Dry, Caring or Fixation setting. � The Quick-Dry setting 6 The Quick-Dry setting enables you to dry shower-wet hair very quickly (fig. 3).
. .

Concentrator The concentrator enables you to direct the airflow straight at the brush or comb with which you are styling your hair. 1 Connect the concentrator by simply snapping it onto the appliance. Disconnect it by pulling it off (fig. 8). 2 Switch the appliance on by setting the airflow slide to position I or II. 3 While you are drying your hair with the concentrator, you can use a brush or comb to style your hair (fig. 9).

� � � � � � � � � �

2

3

4

5

6

7

8

9