JVC HR-IP820U
Instrukcja Obsługi

HR-IP820U INDEX Plus+

97.5.20 5:45 PM

Page 14

Recording
Setting The Cable Box Channel Number
After the record mode is initiated, the cable box channel number must be set if a cable box is in use. The screen will ask for the cable box channel number. b Insert a tape. If the screen to the right appears (as when using a tape that already has a Tape Number and has been entered), skip to step 4. c Insert a tape. If the screen to the right appears (as when using a tape that has a directory which is not recognized by your VCR), skip to step 5. 2 Start recording.The screen to the right appears:
DIRECTORY DOES NOT EXIST IN THIS VCR

TAPE#0123 MUSIC TV

Procedure
1 Enter the cable box channel number using the DIGIT keys. 2 Press ENTER.

Setting The Tape Number
After recording has been initiated, the VCR must know the Tape Number before the data can be stored in memory. If you know the number but the VCR can't read it, you need to enter it. When using a brand new tape, you have to command the VCR to assign a Tape Number for you. The procedure differs slightly depending on the situation.

RECORDING...

Preparation
1. Turn on the power to the TV and the VCR. 2. Set the TV to the channel or mode appropriate for video playback.

TAPE# CAN NOT BE READ 1 INPUT TAPE# 2 CREATE NEW TAPE# PRESS(1)or(2)

Press 2, or don't press either 1 or 2. The new Tape Number is automatically assigned. Go to step 6. 3 Start recording. The screen to the right appears:

Procedure
1 a Insert a tape. If the screen to the right appears (when using a new tape or one recorded on a nonINDEX Plus+ VCR), continue from step 2.
TAPE# CAN NOT BE READ

RECORDING...

TAPE# CAN NOT BE READ 1 INPUT TAPE# 2 CREATE NEW TAPE# PRESS(1)or(2)

Press 1. The screen to the right appears:

ATTENTION:
� When using an RI tape, if the screen in step 1 a appears, skip to step 3. � If you use a tape that already has a Tape Number and has been recorded on, but has not been entered in the library, the screen in step 1 a appears. Skip to step 3. � In the event that you press STOP at the "READING TAPE# . . ." screen, stopping Tape Number reading partway through . . . . . . if the inserted tape has not yet been assigned a Tape Number, go to step 2. . . . if the inserted tape has already been assigned a Tape Number, go to step 3.

TAPE# [ ]
PRESS(DIGITS) THEN PRESS(ENTER) PRESS(CLEAR)TO MAKE CORRECTION PRESS(CANCEL)TO RETURN

Use the DIGIT buttons to enter the Tape Number. (To make corrections to the number you've entered, press CLEAR and input the correct number. To quit the process, press CANCEL and the previous screen reappears.) Once the correct number has been input, press ENTER.

Continued on next page.

14