JVC HR-J313EU
Instrukcja Obsługi

22 EN

TIMER RECORDING
With SHOWVIEW, timer programming is greatly simplified because each TV programme has a corresponding code number which your recorder is able to recognize.

SHOWVIEW Timer 1 Programming
Before performing SHOWVIEW Timer Programming: � Make sure that the recorder's built-in clock is set properly. � Insert a cassette with the safety tab in place. The recorder will come on automatically. � Turn on the TV and select the VIDEO channel (or AV mode).

ACCESS SHOWVIEW SCREEN
Press PROG.

SHOWVIEW

[0 � 9] = [+/�] : EXPRESS PROGRAMING [PROG] : EXIT

The front display panel looks like this:

2
1
NUMBER

Press the NUMBER keys to enter the SHOWVIEW number of a programme you wish to record. � If you make a mistake, press and input the correct number.

ENTER SHOWVIEW NUMBER
SHOWVIEW 12345678

2 5 8 0

3
2

[0 � 9] = [ ] : DELETE [PROG] : EXIT

4 7

6 9
4

The SHOWVIEW number you enter appears on the front display panel:

The display panel can show only a 4-digit number.

PROG

1

?

Press OK, and the

ACCESS SHOWVIEW PROGRAM SCREEN
SHOWVIEW Program screen appears (if you�re just starting out, �P1� appears). The display panel shows the programme start time. Pressing changes the display to the programme stop time, then the date and channel position.
SHOWVIEW START 21:00 � P1 � 123456789 STOP = 22:00 VPS/PDC OFF

3
3

OK

DATE 25.12 : OK

TV PROG 1 ARD

IMPORTANT
Make sure the channel position number you wish to record is displayed; if not, see "SHOWVIEW Setup" on page 35 and set the Guide Program number for that SHOWVIEW number correctly. � If the number you entered is invalid, "ERROR" appears on the screen and "Err" appears on the display panel. Press and input a valid SHOWVIEW number. � If the "GUIDE PROG SET" screen appears, see "ATTENTION � Regarding Guide Program Number Set" on page 23.