Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 26 (kliknij aby zobaczyć)
26 EN
TIMER RECORDING
®
You can use the on-screen display to enter the SHOWVIEW number.
SHOWVIEW Timer Programming
Before performing the SHOWVIEW Timer Programming:
� Make sure that the recorder�s built-in clock is set properly. � Insert a cassette with the safety tab in place. The recorder will come on automatically. � Turn on the TV and select the video channel (or AV mode).
A Access the SHOWVIEW screen.
Press PROG.
The front display panel looks like this:
LCD panel
B Enter the SHOWVIEW number.
Press the number keys to enter the SHOWVIEW number of a programme you wish to record. Then press OK.
� If you make a mistake, press & and input the correct number.
The SHOWVIEW number you enter appears on the front display panel with only a 4-digit number:
simplified because each TV programme has a corresponding code number which your recorder is able to recognize. You can use the remote control with LCD panel to enter the SHOWVIEW number.
With the SHOWVIEW system, timer programming is greatly
C Access the SHOWVIEW Program screen.
The SHOWVIEW Program screen appears (if you�re just starting out, �P1� appears).
A Access the SHOWVIEW display.
Press LCD PROG.
The LCD panel looks like this: The front display panel shows the programme start time. Pressing " changes the display to the programme stop time, then the date and channel position.
B Enter the SHOWVIEW number.
� If you make a mistake, press & and input the correct number. The SHOWVIEW number you enter appears on the LCD panel:
Press the number keys to enter the SHOWVIEW number of a programme you wish to record. Then press .
IMPORTANT
Make sure the channel position number you wish to record is displayed; if not, see �SHOWVIEW System Setup� on page 71 and set the Guide Program number correctly.
®
Then go to step 3 in the right column.
� If the number you entered is invalid, �ERROR� appears on the TV screen and �Err� appears on the front display panel. Press & and input a valid SHOWVIEW number. � If the �GUIDE PROG SET� screen appears, see �ATTENTION� on page 27.
